top mount single turbo...help
i don't know what tial wastegate spring should i choose for the top mount turbo 5862 twin scroll the taller springs or the shorter?? * also about the MAC boost solenoid, do i need any extra wire to...
View ArticleHelp car will not start back up.
So I replaced my transmission after my last auto blew. Put my top mount single on at the same time. Car started up great, but I didn't get a chance to drive it yet. So today I go outside to start it...
View ArticleCobb V3 logging issues
I recently upgraded to the V3 from the V2 and my unit will not log more than 20 parameters. I was able to get 22 parameters with the V2 which I need for my PTF sessions. I called Cobb and was told that...
View Articlehow to connect the MAC solenoid...
how to power it up i connect every thing but the power wires?? there r two wires OEM each wire with two wires orange and white so the total is 4 how to connect them to the mac solenoid?? ASAP.
View Articleplease take a look at this log
mods are jb4g5, dci, wedge e30 flash, walboro fuel pump upgrade and e45 http://www.datazap.me/u/shaun335i/we...10-11&mark=111 my iat's are high next mod in a vrsf 7in ic. thanks
View ArticleMy Top Mount Single Turbo Build 135i 6AT N54.
The kit from FFtec ( 5862turbo ), the tune jb4, everything runs great i updated the jb4 firmware to the single turbo, but i can't do the Single BB flash, because i have the stock turbos 6AT_race flash...
View ArticleWarnings to 335is owners and possible others?
Little back ground. I have a 2011 335is manual with 20k miles. Modifications include cobb flash, FMIC, DPs, Intake, and RB upgraded turbos. Everything was on the car when I brought it to the dealer but...
View Articleislandroad83 has just uploaded Stock 0IA0S E61 2008 XI AT!
islandroad83 has just uploaded Stock 0IA0S E61 2008 XI AT! Stock 0IA0S E61 2008 XI A
View ArticleGot my Blackstone oil analysis report back....
Since I do a lot of experimenting and run a fairly non-standard setup, I sent my oil out for analysis. Various specs on the car that may influence these results: BMS DCI ER oil cooler Runs on 100% E85...
View ArticleSTFT Banks 1 & 2 - What is normal ?
Is it normal for STFT Banks 1 and 2 to be off from each other, and by how much is considered normal ? http://www.datazap.me/u/buraq/beastm...ata=2-13-14-15 The only thing I found when searching was...
View ArticleE85 single turbo 6466 logs
Finally decided to save a couple logs on straight E85 to post up. 6466 custom single turbo 22/23psi E85 Meth flow starting at 5psi and not full flow in these logs.. ill try to get some later with full...
View ArticleMSD81 Engine Loom : Where are the knock sensors?
As in the title, trying to track down the knock sensors on the wiring loom.
View ArticleAnother single kit in the works.
I'm going to be fabbing up a top mount s372 T4 kit on my friends 335i. I am very familiar with tunerpro and EFI tuning priciples, since I have been tuning EFI systems for well over 10yrs. I have a BT...
View Articlehow to connect the MAC solenoid...
how to power it up i connect every thing but the power wires?? there r two wires OEM each wire with two wires orange and white so the total is 4 how to connect them to the mac solenoid?? ASAP.
View Articleplease take a look at this log
mods are jb4g5, dci, wedge e30 flash, walboro fuel pump upgrade and e45 http://www.datazap.me/u/shaun335i/we...10-11&mark=111 my iat's are high next mod in a vrsf 7in ic. thanks
View ArticleMy Top Mount Single Turbo Build 135i 6AT N54.
The kit from FFtec ( 5862turbo ), the tune jb4, everything runs great i updated the jb4 firmware to the single turbo, but i can't do the Single BB flash, because i have the stock turbos 6AT_race flash...
View ArticleWarnings to 335is owners and possible others?
Little back ground. I have a 2011 335is manual with 20k miles. Modifications include cobb flash, FMIC, DPs, Intake, and RB upgraded turbos. Everything was on the car when I brought it to the dealer but...
View Article