First VTT Intakes, Charge pipe, and SIngle Barrel installed

Since our production samples were a perfect fit, we decided to install them on a friends car, along with a set of Billet Stage 2's, the first Production Single Barrel kit, put some miles on them, and hit the dyno soon. We are very pleased to say the intakes fit perfectly, we could not ask for a better fit. The charge pipe took a little adjusting to get it on the car as it is a production sample that is not final, but with these adjustments we were able to finalize the design, and have another sample coming soon to test fit, with that said, it fit very nicely even though it is not final. The Single Barrel, fit amazing as well. Tucked in the tightly you cannot even see it hiding in the depths..:violence-uzi:

On first start up, the HPFP was almost pegged at 3500 as the DME had to adjust down from normal idle voltage to compensate for the extra fuel it provides, after 10-15 seconds the DME figured it out and HPFP was rock solid right where it should be.

Here are a few pics of everything installed. Take look at how perfect the rear intake bung is positioned to accept the OCC hose, its literally a 2 inch piece of hose, keeping everything as short as possible for the least amount of restriction.

All and all we are super pleased with these parts, and look forward to seeing how do on the dyno, as well as getting them into your hot little hands...:music-rockout: