Just wanted to share some pics about my DIY Walbro 450 bucket. I wanted clean and reliable installation and to do it myself. I'm not going on any markets with this setup and there's no improvements on flow characteristics compared to any other setup.
All components are made out of marine/surgical grade stainless (AISI 316L). Joints are done with silver brazing. and the top connector for the venturi pipe is normally used in industrial grease/oil systems which normally have over 400 bar pressure.
![Click here to enlarge]()
![Click here to enlarge]()
![Click here to enlarge]()
![Click here to enlarge]()
![Click here to enlarge]()
![Click here to enlarge]()
![Click here to enlarge]()
All components are made out of marine/surgical grade stainless (AISI 316L). Joints are done with silver brazing. and the top connector for the venturi pipe is normally used in industrial grease/oil systems which normally have over 400 bar pressure.