Hi guys I'm new to this forum
so here what's happening
I read my ecu using the BB flash ap which went fine. But when I tried to load the bms pump gas backend flash it completed the write and then said bad file PAF Mis match. So I then tried to load my standard BIN and my voltage would not read. Tried to load it anyway and got message saying bad file which you will see in the pic. Then ecu went into recovery mode. Iv tried disscomnecting the battery many times with no luck. Now every time I try to load my standard BIN it gets to the 3rd stage and says in red cannot erase memory. You will see this in the other pic. I'm completely lost on what to do from here. Any info would be appreciated. Just for info when I first tried to write the voltage read 13.837 v I was using a 40amp charger as well, the laptop is acer e1-571 with an i5 processor it's the only laptop I have access to!
My car is a late 2006 model 335i with kline ececu any help on this will be greatly appreciated
so here what's happening
I read my ecu using the BB flash ap which went fine. But when I tried to load the bms pump gas backend flash it completed the write and then said bad file PAF Mis match. So I then tried to load my standard BIN and my voltage would not read. Tried to load it anyway and got message saying bad file which you will see in the pic. Then ecu went into recovery mode. Iv tried disscomnecting the battery many times with no luck. Now every time I try to load my standard BIN it gets to the 3rd stage and says in red cannot erase memory. You will see this in the other pic. I'm completely lost on what to do from here. Any info would be appreciated. Just for info when I first tried to write the voltage read 13.837 v I was using a 40amp charger as well, the laptop is acer e1-571 with an i5 processor it's the only laptop I have access to!
My car is a late 2006 model 335i with kline ececu any help on this will be greatly appreciated