I have a BT cable/software and I am looking to log these values:
Lambda (Bank 1) Internal wide-band oxygen sensor bank 1.
Lambda (Bank 2) Internal wide-band oxygen sensor bank 2.
Ped Pos. (%) Accelerator pedal position.
TPS Act. (%) Actual Throttle position.
Timing Cyl. (1) Ignition timing in degrees before top dead center.
Load Act. Actual calculated engine load value.
Load Req. Requested calculated Load from the ECU.
Coolant Temp. Engine coolant temperature.
Engine Oil Temp. Engine oil temperature.
Charge Air Temp. T-Map sensor value of charge air temperature.
Boost Error The Difference between Boost mean and requested.
Req. Boost Abs. Requested boost calculated by the DME in an absolute value.
Boost Mean Abs. A rolling mean average of boost.
Boost Set point Factor Boost pressure set point factor utilized by WGDC system.
Boost Manifold Absolute Pressure.
RPM Engine speed in revolutions per minute.
Vehicle speed Speed calculated by vehicle speed sensor.
Wastegate Duty Base Base percentage of wastegate solenoid duty cycle (0 to 100%).
Wastegate Duty After PID Percentage wastegate solenoid duty cycle after system PID control
(0 to 100%).
Wastegate Duty Bank 1-2 % - Percentage of actual wastegate solenoid duty cycle at bank 1 (0 to
100%).
STFT 1-2 Short term fuel trims for bank one and two displayed in %. (See LTFT for description)
LTFT Bank 1-2 Long term fuel trims for bank one and two displayed in %.
Does anyone have a recall file or know what these would be labeled as?
Thank You
Quote:
Lambda (Bank 1) Internal wide-band oxygen sensor bank 1.
Lambda (Bank 2) Internal wide-band oxygen sensor bank 2.
Ped Pos. (%) Accelerator pedal position.
TPS Act. (%) Actual Throttle position.
Timing Cyl. (1) Ignition timing in degrees before top dead center.
Load Act. Actual calculated engine load value.
Load Req. Requested calculated Load from the ECU.
Coolant Temp. Engine coolant temperature.
Engine Oil Temp. Engine oil temperature.
Charge Air Temp. T-Map sensor value of charge air temperature.
Boost Error The Difference between Boost mean and requested.
Req. Boost Abs. Requested boost calculated by the DME in an absolute value.
Boost Mean Abs. A rolling mean average of boost.
Boost Set point Factor Boost pressure set point factor utilized by WGDC system.
Boost Manifold Absolute Pressure.
RPM Engine speed in revolutions per minute.
Vehicle speed Speed calculated by vehicle speed sensor.
Wastegate Duty Base Base percentage of wastegate solenoid duty cycle (0 to 100%).
Wastegate Duty After PID Percentage wastegate solenoid duty cycle after system PID control
(0 to 100%).
Wastegate Duty Bank 1-2 % - Percentage of actual wastegate solenoid duty cycle at bank 1 (0 to
100%).
STFT 1-2 Short term fuel trims for bank one and two displayed in %. (See LTFT for description)
LTFT Bank 1-2 Long term fuel trims for bank one and two displayed in %.
Thank You