I went to do BB flash, plugged in a battery charger to the car and the laptop. It said it was taking like 3 hours just to READ which seemed really weird. So 5 hours in, I unplugged it because it wasn't moving. After I did this I started my car and I couldn't go into my jb4 through steering or usb cable, and also after about 15sec of the car being on, it would just basically cut fuel and stall.
So I ended up plugging in another laptop, voltage meter was good on the interface and I ended up reading my car (hour or so) and writing the e85 map to my car(15mins or so).
When I started the car with the g5 in again the same thing happened it would start and just stall after about 10-15sec. And I still couldn't get into the jb4 through steering wheel or usb. I plugged my g4 in, and it started up, and there was a ton of smoke coming out of my exhaust (i figured because I didn't change my settings on my g4 to 0). It smelled like pure e85 but it ran and I could enter the jb4 menu. Then I plugged g5 back in and same thing happened where it would stall and couldn't access g5 through USB or the steering wheel.
Any help would be greatly appreciated.
So I ended up plugging in another laptop, voltage meter was good on the interface and I ended up reading my car (hour or so) and writing the e85 map to my car(15mins or so).
When I started the car with the g5 in again the same thing happened it would start and just stall after about 10-15sec. And I still couldn't get into the jb4 through steering wheel or usb. I plugged my g4 in, and it started up, and there was a ton of smoke coming out of my exhaust (i figured because I didn't change my settings on my g4 to 0). It smelled like pure e85 but it ran and I could enter the jb4 menu. Then I plugged g5 back in and same thing happened where it would stall and couldn't access g5 through USB or the steering wheel.
Any help would be greatly appreciated.
