Hi guys:
I'm currently running the OFT stage 1 map stacked with Procede for meth control.
I have been trying to get my boost target 1 psi higher between 5K and 5.5K rpms.....but it's been a struggle.
I upped the load table in that rpm range from 200 to 205.....but found it did nothing to help increase boost.
Then while reading the Cobb "How-to" sticky I found a reference to the WGDC % limit table and increased the value in this table from the original 57% up 70% duty cycle.
So it seems that should have provided some more headroom for additional duty cycle in order to hit higher boost.
But when I look at the WGDC Ceiling Adder table......I see that cap of 57 again :facepalm.
Do these two tables need to match in order for my change of 70% to work in order to raise the boost target?
.
.
.
![Click here to enlarge]()
I'm currently running the OFT stage 1 map stacked with Procede for meth control.
I have been trying to get my boost target 1 psi higher between 5K and 5.5K rpms.....but it's been a struggle.
I upped the load table in that rpm range from 200 to 205.....but found it did nothing to help increase boost.
Then while reading the Cobb "How-to" sticky I found a reference to the WGDC % limit table and increased the value in this table from the original 57% up 70% duty cycle.
So it seems that should have provided some more headroom for additional duty cycle in order to hit higher boost.
But when I look at the WGDC Ceiling Adder table......I see that cap of 57 again :facepalm.
Do these two tables need to match in order for my change of 70% to work in order to raise the boost target?
.
.
.